newRPL - Updated to build 1510 [official build remains at 1487]

[spiff72]

(01-28-2023 05:02 AM)spiff72 Wrote:  

(10-06-2022 02:32 PM)Klaus Wrote:  Hello, installed the new firmware for HP 50 and newRPL Desktop on Windows PC (Win11). The USB dialog recognizes the HP50 but also tells me that the device is not responding. I upgraded my PC to Win11 a few days ago. Win10 everything perfect. What can I do?
Greetings Klaus

I know this is an older post, but I just confirmed that I was able to update the firmware from 1487 to 1509 (reported by "VERSION" on the calc) on my Prime G1 using the newRPL desktop on a Windows 11 PC. I plugged directly into the USB port of the laptop (no hub or anything). I thought this was supposed to be 1510?

Anyway, once the upgrade was done, I am no longer able to get the PC to recognize the calculator. So it worked once, and that was it ;-)

UPDATE:
I ended up resetting the calculator with the button on the back, and went back into newRPL via the On+Symb then Esc commands. I plugged into the PC again, and it was recognized.

However, I have of course lost all my variables/memory (I had been using the Prime firmware for quite a while until just now...

I was checking to see if I did a USB archive backup to the PC, but apparently I didn't. I am pretty sure that I did one on the calc with the SDARCHIVE command, but I don't recall the syntax (or the filename, if there was one) to do the restore. Is there a way to see what I have saved as archive files?