HP Forums / HP Calculators (and very old HP Computers) / General Forum v / (41C) How to edit & debug complex programs?

Post Reply 
(41C) How to edit & debug complex programs?
04-16-2023, 01:25 AM (This post was last modified: 04-16-2023 01:56 AM by Craig Bladow.)
Post: #14
Craig Bladow Offline
Senior Member
 		Posts: 418
Joined: Apr 2016
RE: (41C) How to edit & debug complex programs?
(04-15-2023 10:51 PM)acser Wrote:  Just tried this, it works nicely, thank you. A difference from the HP41 is that PSE commands do not allow for X stack modification. Also, it would be nice to accept the sequence "!=" as the "<>" (not equal) sequence Smile (+41CX on iOS generates !=) Thank you. Smile

It will be in the next release as x!=y? as an alias for x<>y? and x!=0? for x<>0? Smile

I'll document the PSE behavior difference in the manual and put it on my to do list to see what can be done in the future.

Cheers
Try CC41!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: (41C) How to edit & debug complex programs? - Craig Bladow - 04-16-2023 01:25 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication