New HP Prime update 2.1.14730

[toml_12953]

(05-01-2023 05:14 PM)froehlic Wrote:  

(04-29-2023 12:32 AM)calc_freak Wrote:  Not just you. The exact same thing happens on my Rev C. Can't add any programs or even look at anything via the Conn Kit before it crashes the calculator and it restarts.

I had the same problem with my Rev C. Rev D was working out of the box after the update.
I solved the problem with the C-F-O-Reset (while the prime is off, press keys C,F and O and hold them. Then turn it on and release C/F/O if you are in the diagnostic menue). Then choose "4 FLS Utility" and after that "3 Format Disk C". After formatting and reset you have an empty prime but still the new firmware. Then I connected it to CK and I started to copy my programs and I could open the tree in CK again.

Hope this works for you too!

Best regards
Frank

Thanks, Frank! Your tip worked on both my HW C calculators.