Correct volts out on HP-45 PSU

[Pennine_Lad]

Hi

Many thanks for the info. The volts on the board do match those and have since found a break in the middle wire somewhere between board and plug.

Any tricks of the trade to isolate to keep as much of good length as possible.

Tried a sewing pin through middle cable for continuity check either end but too hit and miss as do not know if have touched wires. Perhaps shave a little off insulation so know touching and then heatshrink those when repaired.

May not need many shaved areas, if do half way down wire, then half way down again the bad half and again on the bad quarter it may narrow down quickly.

David