HP-41 Barcode Scanner and Generator

[vervalin]

Hi Michael,

Ok, so now I feel like I am cluttering the thread :-(

So, I have tried some additional things and I cannot explain reason for the results. But I do not think it matters now. I have used my wand to read in the barcode from version 1.11 again. This time it has worked and no erroneous lines of code are entered into the calculator.

Yesterday, I read the same sheets of barcode into two different calculators and each calculator had bad results. In one instance, the program read in could not even "pack" correctly. In the other instance, there were corrupted lines of code in the program.

But, now this third reading of the same printed PDF sheets with the wand has produced good results. In each of the three attempts, the calculator gave a successful "beep" for each line read by the wand. So, it is most certainly related to my "system" in some way as the PDF barcode printouts are clearly good.

I was not aware that this is possible to get a good "beep" but to have the program lines corrupted.

Thank you and sorry if I have created any difficulties...