HP Forums / Not HP Calculators / Not remotely HP Calculators v / Help needed - orientation for LED and capacitor

Post Reply 
Help needed - orientation for LED and capacitor
09-15-2023, 06:54 PM
Post: #2
Steve Simpkin Offline
Senior Member
 		Posts: 1,297
Joined: Dec 2013
RE: Help needed - orientation for LED and capacitor
The capacitor you list is a .1 uF (aka 104) ceramic capacitor and has no polarity. Just install it for C1 without regard to orientation.

The LED should have a flat side as shown in the picture below. From the populated cartridge picture you provided, it looks like the flat side of the LED is toward the bottom of the board. The silk screen on your board also has a flat side on it. Install the LED so that the flat side matches the silkscreen.

   
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Help needed - orientation for LED and capacitor - Steve Simpkin - 09-15-2023 06:54 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication