Post Reply 
Improving FIX mode
10-20-2023, 04:39 PM
Post: #11
RE: Improving FIX mode
(10-20-2023 03:38 PM)Pyjam Wrote:  
(10-20-2023 02:56 PM)agarza Wrote:  Switching to SCI 7, 8 or 9
will not round, and show:
9.000000 00 (no rounding applied)

It’s not a bug, it’s a feature!
Owner’s Handbook, top of page 59.

SCI mode is in practice limited to 6 positions on the machines, I guess.

But I don't like that "feature"!
I know it is rounding, but since the display in SCI or ENG only shows 7 digits + EEX, the rounding is done off the screen and not shown.
Doing the same example with FIX, the screen rounding works fine.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Improving FIX mode - c3d - 10-16-2023, 12:08 PM
RE: Improving FIX mode - Albert Chan - 10-16-2023, 01:28 PM
RE: Improving FIX mode - c3d - 10-16-2023, 08:27 PM
RE: Improving FIX mode - Pyjam - 10-20-2023, 08:07 AM
RE: Improving FIX mode - Albert Chan - 10-20-2023, 10:59 AM
RE: Improving FIX mode - c3d - 10-20-2023, 05:07 PM
RE: Improving FIX mode - c3d - 10-20-2023, 04:51 PM
RE: Improving FIX mode - c3d - 10-20-2023, 05:58 PM
RE: Improving FIX mode - Pyjam - 10-20-2023, 11:17 AM
RE: Improving FIX mode - Albert Chan - 10-20-2023, 02:00 PM
RE: Improving FIX mode - c3d - 10-21-2023, 08:53 AM
RE: Improving FIX mode - Pyjam - 10-21-2023, 10:24 AM
RE: Improving FIX mode - c3d - 10-21-2023, 11:26 AM
RE: Improving FIX mode - Pyjam - 10-20-2023, 02:25 PM
RE: Improving FIX mode - agarza - 10-20-2023, 02:56 PM
RE: Improving FIX mode - Pyjam - 10-20-2023, 03:38 PM
RE: Improving FIX mode - agarza - 10-20-2023 04:39 PM
RE: Improving FIX mode - Pyjam - 10-20-2023, 05:36 PM



User(s) browsing this thread: 2 Guest(s)