A new old bug in the printer ROM?

Threaded Mode | Linear Mode

A new old bug in the printer ROM?

10-23-2023, 03:49 PM

Post: #16

MeindertKuipers Offline

Senior Member

Posts: 325
Joined: Dec 2013

RE: A new old bug in the printer ROM?

Unfortunately it is not so simple. The Blinky module has a number of registers with status bits and control words, and these are not documented. It would take a lot of monitoring and reverse engineering to sort that out.

Regards, Meindert

« Next Oldest | Next Newest »

Messages In This Thread

A new old bug in the printer ROM? - ThomasF - 01-16-2023, 07:25 PM

RE: A new old bug in the printer ROM? - Christoph Giesselink - 01-16-2023, 10:07 PM

RE: A new old bug in the printer ROM? - ThomasF - 01-17-2023, 05:59 AM

RE: A new old bug in the printer ROM? - MeindertKuipers - 01-17-2023, 09:21 AM

RE: A new old bug in the printer ROM? - Christoph Giesselink - 01-17-2023, 06:38 PM

RE: A new old bug in the printer ROM? - ThomasF - 01-18-2023, 07:24 AM

RE: A new old bug in the printer ROM? - Tinue - 10-20-2023, 07:56 AM

RE: A new old bug in the printer ROM? - rprosperi - 10-20-2023, 12:15 PM

RE: A new old bug in the printer ROM? - MeindertKuipers - 10-21-2023, 01:59 PM

RE: A new old bug in the printer ROM? - Tinue - 10-23-2023, 08:11 AM

RE: A new old bug in the printer ROM? - brouhaha - 10-23-2023, 08:29 AM

RE: A new old bug in the printer ROM? - ThomasF - 12-09-2023, 09:58 AM

RE: A new old bug in the printer ROM? - Christoph Giesselink - 01-18-2023, 07:38 PM

RE: A new old bug in the printer ROM? - Tinue - 10-23-2023, 11:21 AM

RE: A new old bug in the printer ROM? - brouhaha - 10-24-2023, 05:08 AM

RE: A new old bug in the printer ROM? - MeindertKuipers - 10-23-2023, 01:04 PM

RE: A new old bug in the printer ROM? - Tinue - 10-23-2023, 02:30 PM

RE: A new old bug in the printer ROM? - brouhaha - 10-24-2023, 11:27 AM

RE: A new old bug in the printer ROM? - ThomasF - 10-25-2023, 05:17 PM

RE: A new old bug in the printer ROM? - MeindertKuipers - 10-23-2023 03:49 PM

User(s) browsing this thread: 2 Guest(s)