Base conversion for DM41X

Threaded Mode | Linear Mode

Base conversion for DM41X

10-24-2023, 02:33 PM

Post: #11

Jeff_Birt Offline

Senior Member

Posts: 304
Joined: Dec 2021

RE: Base conversion for DM41X

(10-22-2023 07:41 PM)Sylvain Cote Wrote: The following non-optimized program works on all 41's (C, CV, CX, 41CL, DM41X, etc) and assumes that the top row key is unassigned.

Thanks Sylvain, this was helpful.

« Next Oldest | Next Newest »

Messages In This Thread

Base conversion for DM41X - Jeff_Birt - 10-21-2023, 11:52 PM

RE: Base conversion for DM41X - Sylvain Cote - 10-22-2023, 01:54 PM

RE: Base conversion for DM41X - Jeff_Birt - 10-22-2023, 03:33 PM

RE: Base conversion for DM41X - Valentin Albillo - 10-22-2023, 04:16 PM

RE: Base conversion for DM41X - Jeff_Birt - 10-22-2023, 06:41 PM

RE: Base conversion for DM41X - Valentin Albillo - 10-22-2023, 11:32 PM

RE: Base conversion for DM41X - Jeff_Birt - 10-23-2023, 01:05 PM

RE: Base conversion for DM41X - Valentin Albillo - 10-23-2023, 06:13 PM

RE: Base conversion for DM41X - Sylvain Cote - 10-22-2023, 07:41 PM

RE: Base conversion for DM41X - Jeff_Birt - 10-24-2023 02:33 PM

RE: Base conversion for DM41X - Werner - 10-23-2023, 06:54 AM

User(s) browsing this thread: 1 Guest(s)