Clonix issue with built-in HEPAX
|
11-11-2023, 09:55 AM
(This post was last modified: 11-11-2023 09:56 AM by Jurgen Keller.)
Post: #5
|
|||
|
|||
RE: Clonix issue with built-in HEPAX
Sylvain, thank you much for your efforts and the detailed report. Good to see that - in principal - it works.
I've noticed a few things: the built-in HEPAX is version 1C, not a 1D. I don't know the differences between those two versions and if that could be a source for the problems. Second thing is that I have a CLONIX-41, not a CLONIX-D. But again, I don't know if this makes any difference. As I also have a NoV-32, I tried that with another 41CX, and I burned the HEPAX, Zenrom and SkwidBC into it. Works like a charm. Third thing I noticed is that the file related functions did not work properly on the 41CX with built-in HEPAX. HEPDIR gave strange outputs and I could not create a file at all. I checked the links in the RAM pages and they were wrong, however, I could not edit them. The reason was that some of the RAM pages were write-protected. I unprotected all RAM pages and cleared them using CLRAM. In the end, the file related functions I tried, like HEPDIR, creating a file, etc., did work properly. But ... when I insert the CLONIX-41, the calculator goes wild. Hmm, weird, I have no clue what's wrong with it. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Clonix issue with built-in HEPAX - Jurgen Keller - 11-10-2023, 02:52 PM
RE: Clonix issue with built-in HEPAX - Sylvain Cote - 11-10-2023, 03:18 PM
RE: Clonix issue with built-in HEPAX - Jurgen Keller - 11-10-2023, 03:55 PM
RE: Clonix issue with built-in HEPAX - Sylvain Cote - 11-10-2023, 08:03 PM
RE: Clonix issue with built-in HEPAX - Jurgen Keller - 11-11-2023 09:55 AM
RE: Clonix issue with built-in HEPAX - Jurgen Keller - 11-11-2023, 01:32 PM
RE: Clonix issue with built-in HEPAX - Diego Diaz - 11-18-2023, 06:30 AM
RE: Clonix issue with built-in HEPAX - Jurgen Keller - 11-26-2023, 11:16 AM
RE: Clonix issue with built-in HEPAX - Artur - Brasil - 01-16-2024, 03:19 PM
|
User(s) browsing this thread: 1 Guest(s)