What happened to Debug-Functionality? Error in manual.
|
12-15-2023, 07:34 PM
Post: #1
|
|||
|
|||
What happened to Debug-Functionality? Error in manual.
In the manual of HP Prime (here) p. 564 there is a screenshot of the debug-mode with the following menu in the bottom line:
Edit - Skip - Step - Swap - Stop - Cont Further on the following menu points are explained: Skip - Step - Vars - Cont - Stop On my HP Prime I find as well: Edit - Skip - Step - Swap - Stop - Cont I remember I selected variables to show their content in former versions of the software. I think this is an error in the manual. But even more important: How can I select the variables of which the content is shown during the debug mode? Any help is appreciated! Thank you very much. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
What happened to Debug-Functionality? Error in manual. - rawi - 12-15-2023 07:34 PM
RE: What happened to Debug-Functionality? Error in manual. - komame - 12-16-2023, 01:15 PM
RE: What happened to Debug-Functionality? Error in manual. - HPCarnace - 12-16-2023, 02:56 PM
RE: What happened to Debug-Functionality? Error in manual. - rawi - 12-16-2023, 07:51 PM
RE: What happened to Debug-Functionality? Error in manual. - StephenG1CMZ - 12-16-2023, 11:08 PM
RE: What happened to Debug-Functionality? Error in manual. - BruceH - 12-16-2023, 11:47 PM
|
User(s) browsing this thread: 1 Guest(s)