HP-IL and EMU71

[Sylvain Cote]

TCP/IP configuration for all software


RESTORE IO followed by DEVID$(5)


In the HP-IL Scope section you see the low level HP-IL commands/messages send over the loop.
The ILPer Scope only show messages coming from the controller in this configuration.

RESTORE IO

Code:

IFC     RFC     
AAU     RFC     
AAD 01          (the following AAD messages are not seen by the HP-IL scope)

DEVID$(5) and the peripheral reply "HP3468A"+CR

Code:

UNL     RFC     
TAD 05  RFC     
SDI     
DAB 48  DAB 50  DAB 33  DAB 34  DAB 36  DAB 38  DAB 41  NRD     DAB 0D  
UNT     RFC     
UNL     RFC

Here is a more complicated diagnostic setup that insert a ILScope before and after the PIL-Box.