HP-41 HP82143A printer repair.

[Papymouzot]

I believe that the home reference is set at switch on, if I move the head manually by rotating the encoder wheel when printer is off, and I switch it on afterwards, the head goes to home position (far right) then motor stops.

The issue could have been dirt, I blowed on the sensor, and now the printer seems to work... I'll see if this lasts.

Nobody would have photos & dimensions of the little transparent plastic cover which should be in front of the paper ?

Thank you all for your help and comments...

The main usage for that is probably to be able to cut the paper. I can't find it and would like to draw one and 3D print it. Of course I can make measurements myself, but I'll be happy to know the shape it should normally have.