Floor & Ceil (RPN-67 vs Excel)

[Matt Agajanian]

(05-24-2024 08:18 PM)stilmant Wrote:  Hi Matt,

So, there are at least three ways to get floor results in Excel, and you mentioned "max mode," which also confuses me.

Thanks!

Michael

By Max mode, I was referring to one of RPN-67's Enhancements setting (Off, Med, Max). 'Off' sets RPN-67 to operate as a vintage HP-67. Where Max mode allows 999 program steps, plus 100 extra data registers, as well as a whole bunch of new functions and lets you check & run parts of your program based on RPN-67's settings and internals (e.g. haptic level, set/check beep type, swap values between primary & secondary registers, using three additional indirect registers, I, J, and K, just a whole bunch of stuff).