Nov64d & PicKit 2

[Papymouzot]

Hello,

I am running into an issue with my first tests of the Nov64d module I received from Diego a couple of weeks ago.

I first tried to create a service module, and it didn't compile correctly, I had an issue with the path being too long...

when I solved this, The created "module" hex file got created I I could write to the module, but when I plugged it in my calculator nothing happened... When I looked in cat 2 the module was invisible

I reprogrammed the module with the default hepax hex and the module seems to have been programmed again and the program I had in ram was still there and I could run it.

Today I tried again...

I used Clonix config utility v6.1 to create a Hepax 1D module plus the advantage module, nothing extraordinary, it seems to be working and PicKit 2 is launched, and this is when I have issues.

I get PicKit 2 VPP voltage level error, check target and retry operation" from time to time, and otherwise I get for the device "unsupported part (ID=3FED)" most of the time. it is impossible to write to the module, although the first time, a few weeks ago, it seems to run fine

When I try the module in the calculator, it still sees the hepax module. and my program

what am I doing wrong ?

what could I test ?