The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 795 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 795 errorHandler->error




HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Communicating with the HP 3421A Data Aquisition/Control Unit

Post Reply 
Communicating with the HP 3421A Data Aquisition/Control Unit
07-26-2024, 12:40 PM
Post: #1
Danilo C. Offline
Junior Member
 		Posts: 1
Joined: Jul 2024
Communicating with the HP 3421A Data Aquisition/Control Unit
Hello everyone. I am not an HP antiques enthusiast, but it has come to be that I must use an HP 3421A in a project I'm participating in.

I am looking for a way to use the HP 3421A without the HP calculators/computers I know it was made to be used with. However, since the material on this piece of technology is pretty scarce, i have not been able to find a straightforward way of doing so. Therefore, I came here to see if any of you know of what i might need to do so.

I have found a user manual for the device, but it has not been very useful in showing me the way, or so to say.

Anything you all may show me will be helpful.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Communicating with the HP 3421A Data Aquisition/Control Unit - Danilo C. - 07-26-2024 12:40 PM



User(s) browsing this thread: 3 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication