Graph3D App Has Problem with New Firmware

[John Colvin]

(09-15-2014 07:48 PM)Han Wrote:  

(09-15-2014 06:48 PM)John Colvin Wrote:  Thank you Han for the updated version. It runs significantly faster on my Prime than the older version when rotating the plot. My original complaint, however, is still there-a minor one but it is likely easily corrected:
When I enter a negative value for the lower limit of either X,y, or z in the range settings, I get an 'Invalid input' error. When I try entering it a second time, it accepts it without error. I don't mind this minor inconvenience but I thought I would call it to your attention anyway.

My suspicion is that you are using RPN mode -- is this correct? If so, I believe that what is happening is that the INPUT() command is auto-inserting the single quotes around your number. I will see if the new features of INPUT() can be used to get around this issue. Otherwise, the developers will have to find a better way for RPN to work with INPUT() calls.

You are correct I am using the app in RPN mode. I don't have the issue in textbook mode.