HP Prime Beta Firmware Version 2.2 Revision 15008

[Guenter Schink]

(08-24-2024 11:33 AM)CheshireChris Wrote:  ...
There's an interesting article on the subject here:

https://eddieantonio.ca/blog/2023/10/25/...-language/

Well worth reading.

That's indeed very interesting. Just for fun, I typed that little snipped into the Prime

Code:

1 / 0
print() = None
if False
    ñ = "hello

after pushing <Num> the calculator would reboot. But then it (almost) behaved as described in the article.
Almost, because the sequence of the identification of errors was the same, but the error descriptions were slightly different.
The rebooting was repeatable. Simply delete (reset) the Python app, type in the code again ... and boom! reboot.

The rebooting didn't occur on my Prime with the new beta SW

Günter