PX41CX

[krischik]

The soldering is was easy enough but the case is a disaster. There is almost no space between the PCB and the aluminium plane. The manual suggest to cut as all wire as close as possible but when you do that you start to damage to PCS with the cutters. Cutters are hardened steel after all.

   

Right now I can't get any closer and it still doesn't fit. Taller washer would have helped. 1 … 2 mm extra thickness is better then a case that doesn't fit.

Well, I will try to grind them down with a Dremel.

An then the connector to AVR Programmer doesn't quite fit in the case. But that is easy enough to fix with a sharp knife.

   

My suggestion is: go for the 3D printed case with short tactile switches.