HP41CX "PRA" Misbehaving on TULIP
|
10-30-2024, 01:16 PM
Post: #4
|
|||
|
|||
RE: HP41CX "PRA" Misbehaving on TULIP
Thanks for the responses. I re-checked "Enable IDY frames" in PYilper and see the "PILBox mode changed to COFI / Controller OFF with IDY" status in the console interface.
I've tried this PRA scenario both ways with little change in behavior. I'm really starting to believe either 1) I am missing something obvious in my virtual setup, or 2) I messed something devious up when I built my TULIP. This seems specific to my TULIP build since physical HPIL devices work perfectly, and nobody else is reporting these issues. I did find U5 behaved oddly when I put a scope on it. It wasn't "not" working, but still odd. For now I have JP2 pulled and U5 pin 3 lifted. Per the schematic this takes the U5 logic out of the picture. I have ordered replacements. I can't see where monitoring FI is critical to the TULIP HPIL function, but I'll ask to be sure. Is FI monitoring important here? |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP41CX "PRA" Misbehaving on TULIP - rocket.scientist - 10-29-2024, 08:56 PM
RE: HP41CX "PRA" Misbehaving on TULIP - Craig Bladow - 10-30-2024, 04:48 AM
RE: HP41CX "PRA" Misbehaving on TULIP - MeindertKuipers - 10-30-2024, 09:29 AM
RE: HP41CX "PRA" Misbehaving on TULIP - rocket.scientist - 10-30-2024 01:16 PM
RE: HP41CX "PRA" Misbehaving on TULIP - ThomasF - 10-30-2024, 01:53 PM
RE: HP41CX "PRA" Misbehaving on TULIP - rocket.scientist - 10-30-2024, 03:54 PM
RE: HP41CX "PRA" Misbehaving on TULIP - born2laser - 10-30-2024, 04:15 PM
RE: HP41CX "PRA" Misbehaving on TULIP - MeindertKuipers - 10-31-2024, 08:50 AM
|
User(s) browsing this thread: 1 Guest(s)