TI-58C Clone

[Marc van Lemmen]

(11-11-2024 10:43 PM)Pierre Wrote:  

(11-11-2024 09:51 PM)Marc van Lemmen Wrote:  Here are some photo's from the assembly/soldering of the ET-58.

Congratulations for this remarkable work !
And thanks for the pictures.
The IC socket was not in the kit! (???)
It must cause an extra thickness?

Otherwise, for the ISP connector it is on the ET-57 that I had seen it.
https://www.breatharian.eu/hw/et57/index_en.html

Best regards
Pierre

Hi Pierre,

Thanks ! The IC socket was not in the kit, I used it because I thought I had to program the 328p and had no way to test it other than on the ET-58 board itself. ( And because there's no ISP connector ).
At the moment I'm printing some new spacers to see if it is workable, only a very small part of the switch extends above the top. I'll keep you informed .......

Kind regards,
Marc.