Post Reply 
LBL and END handling on the PX41CX and in PX41CX_Interface.xls
11-12-2024, 04:33 PM (This post was last modified: 11-12-2024 04:38 PM by Sylvain Cote.)
Post: #3
RE: LBL and END handling on the PX41CX and in PX41CX_Interface.xls
(11-12-2024 07:45 AM)krischik Wrote:  What I find especially interesting is the „0=compiled or 1=not compiled“ flag for the END command which I found in the hp41cx-prog-handbook.pdf. Does anybody know what precisely is compiled.
The compiled bit was supposed to reflect that all GTO/XEQ offset within a program has been calculated and stored into their respective GTO/XEQ.

In reality, AFAIK the END compile bit is always set to 0, even when none/some/all GTO/XEQ offset has been calculated and stored within them.

edit: I just tested the above statement with the ZENROM RAMED function and I can confirm the (reality) behavior on a 41CLv5.

Sylvain Côté
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: LBL and END handling on the PX41CX and in PX41CX_Interface.xls - Sylvain Cote - 11-12-2024 04:33 PM



User(s) browsing this thread: 5 Guest(s)