HP Forums / Not HP Calculators / Not quite HP Calculators - but related v / LBL and END handling on the PX41CX and in PX41CX_Interface.xls

Post Reply 
LBL and END handling on the PX41CX and in PX41CX_Interface.xls
11-12-2024, 05:02 PM
Post: #4
krischik Offline
Member
 		Posts: 56
Joined: Oct 2021
RE: LBL and END handling on the PX41CX and in PX41CX_Interface.xls
(11-12-2024 04:33 PM)Sylvain Cote Wrote:  
(11-12-2024 07:45 AM)krischik Wrote:  What I find especially interesting is the „0=compiled or 1=not compiled“ flag for the END command which I found in the hp41cx-prog-handbook.pdf. Does anybody know what precisely is compiled.
The compiled bit was supposed to reflect that all GTO/XEQ offset within a program has been calculated and stored into their respective GTO/XEQ.

That is what I suspected. Thanks for confirming. In PX41CX_Interface.xls Pierre relies on those values to be 0 which of course doesn't work in all conditions. And since I copied his code I ran into all sorts of trouble.

Regards
Martin
https://uiq3.sf.net/rpn-45/
Developer RPN-45, FX-602P Simulator, FX-603P Simulator
HP16C, HP35s, HP-Prime, FX-602P, FX-603P, PC-1403
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: LBL and END handling on the PX41CX and in PX41CX_Interface.xls - krischik - 11-12-2024 05:02 PM



User(s) browsing this thread: 6 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication