How to tell if my quad mem is working

[jhughson]

I've done some searching and I think I've mostly just confused myself, so I thought I'd ask, but I think this probably a quick answer kinda thing.

I bought from ebay a quad memory module for my hp-41cv (also an ebay purchase from a long time ago) and I have the X Functions installed and I take the batteries out and install the quad memory and then I power back up and execute emdir and I get 124 when I thought it would be more. Also if I take the quad mem out it also reads 124 when I do EMDIR.

I've read this thread from the archive:
https://www.hpmuseum.org/cgi-sys/cgiwrap...read=54029

and I'm not sure I'm reading it wrong and this config is not supported, or the quad memory is bad. My config is XFunctions in slot 1 and a single quad mem module which I have tried in all 3 other slots. emdir always returns 124.

Thank you and apologies if there was a simple way to figure this out from the documentation.

JR