HP Forums / HP Calculators (and very old HP Computers) / General Forum v / ILPer v1.44 update

Post Reply 
ILPer v1.44 update
10-13-2014, 07:51 PM (This post was last modified: 10-13-2014 07:52 PM by Dave Frederickson.)
Post: #24
Dave Frederickson Offline
Senior Member
 		Posts: 2,250
Joined: Dec 2013
RE: ILPer v1.44 update
(10-11-2014 07:46 AM)J-F Garnier Wrote:  Emu41 - an (very old now) 16-bit, text mode DOS application - can't interact with the Christoph's virtual loop based on TCP/IP.

Would it be possible to access the virtual loop using this technique by Egan Ford using the serial port virtualization using TCP/IP capability of DOSBox and running Emu41 in DOSBox?

Dave
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
ILPer v1.44 update - Christoph Giesselink - 09-30-2014, 06:58 PM
RE: ILPer v1.44 update - rprosperi - 10-01-2014, 12:50 AM
RE: ILPer v1.44 update - Dave Frederickson - 10-01-2014, 02:51 AM
RE: ILPer v1.44 update - Ángel Martin - 10-01-2014, 04:49 AM
RE: ILPer v1.44 update - hp41cx - 10-01-2014, 01:36 PM
RE: ILPer v1.44 update - Sylvain Cote - 10-01-2014, 02:43 AM
RE: ILPer v1.44 update - rprosperi - 10-01-2014, 10:21 PM
RE: ILPer v1.44 update - rprosperi - 10-05-2014, 04:51 PM
RE: ILPer v1.44 update - rprosperi - 10-08-2014, 11:51 PM
RE: ILPer v1.44 update - J-F Garnier - 10-10-2014, 07:02 AM
RE: ILPer v1.44 update - Dave Frederickson - 10-08-2014, 05:33 PM



User(s) browsing this thread: 2 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication