Flashing the WP34s

[BarryMead]

(11-23-2014 06:35 PM)Marcus von Cube Wrote:  Repairing the flash is totally possible with the USB board alone. You just need to perform a full erase to the flash with a piece of wire to activate the SAM-BA boot code.

There have been some posts of people who corrupted the flash to the point that the normal samba boot code no-longer works. These people have had to resort to using the JTAG connector to program the flash.
I too had assumed that the poster was confusing the 6-pin serial programming header with the jtag connector but didnt' want to mention it. He could wire his USB board to the 6-pin serial programming header if he wants, but that would just make the wires longer.