WP34S problem after update

Threaded Mode | Linear Mode

WP34S problem after update

12-06-2014, 11:11 AM

Post: #3

alexcastel70 Offline

Junior Member

Posts: 4
Joined: Dec 2014

RE: WP34S problem after update

Hi,

I haven't crystal installed but I'm sure that the flash image is correct; I have tried with calc.bin and full_calc.bin with the same result.
Calculator seems responding to MySamba: at the end of the procedure I get the message that files was succesfully sent in about 3 seconds but after that I can't turn it on.

Alessandro

« Next Oldest | Next Newest »

Messages In This Thread

WP34S problem after update - alexcastel70 - 12-06-2014, 09:57 AM

RE: WP34S problem after update - Marcus von Cube - 12-06-2014, 10:38 AM

RE: WP34S problem after update - alexcastel70 - 12-06-2014 11:11 AM

RE: WP34S problem after update - Marcus von Cube - 12-06-2014, 11:32 AM

RE: WP34S problem after update - walter b - 12-06-2014, 12:16 PM

RE: WP34S problem after update - alexcastel70 - 12-06-2014, 12:22 PM

RE: WP34S problem after update - walter b - 12-06-2014, 12:27 PM

RE: WP34S problem after update - Massimo Gnerucci - 12-06-2014, 12:30 PM

RE: WP34S problem after update (solved) - alexcastel70 - 12-06-2014, 05:01 PM

User(s) browsing this thread: 3 Guest(s)