WP34s Programming Cable

[Bit]

(02-01-2015 02:55 PM)John Galt Wrote:  

(02-01-2015 06:25 AM)Bit Wrote:  If you get the amount of plastic that flows into the sides right, it'll be strong enough to oppose the force of the pins but not difficult to insert or remove the plug manually.

That makes sense. I suppose if you can't remove the plug, you could always insert the entire back cover in hot water to soften it, right?

Yes, or you can use a hairdryer, or you could remove the plug before it completely solidifies and help it with a small knife or similar tool from behind.