HP 82162A repair drive belt
|
02-01-2015, 04:38 PM
Post: #7
|
|||
|
|||
RE: HP 82162A repair drive belt
(01-25-2015 10:55 PM)Jurgen Keller Wrote: In the referenced post the size was specified as 0.75" (inner diameter) and 0.04" (thickness). Converted to metric units this would be 19 x 1 mm. I guess I've found a source here in Switzerland: I've got the o-ring mentioned above, and my printer works again :-) However, the 1mm o-ring seem to be a little bit thinner than the original one. I think the 1.5mm (also available from the source referenced above) would be closer to the original drive belt. See attached picture. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP 82162A repair drive belt - Jurgen Keller - 01-25-2015, 08:40 PM
RE: HP 82162A repair drive belt - Marcus von Cube - 01-25-2015, 10:16 PM
RE: HP 82162A repair drive belt - rprosperi - 01-25-2015, 10:26 PM
RE: HP 82162A repair drive belt - Jurgen Keller - 01-25-2015, 10:55 PM
RE: HP 82162A repair drive belt - Jurgen Keller - 02-01-2015 04:38 PM
RE: HP 82162A repair drive belt - Etienne Victoria - 01-25-2015, 11:56 PM
RE: HP 82162A repair drive belt - Etienne Victoria - 01-26-2015, 08:35 AM
|
User(s) browsing this thread: 1 Guest(s)