WP34s 20b Repurposed

[MarkHaysHarris777]

(02-13-2015 10:57 PM)matthiaspaul Wrote:  

(02-13-2015 08:48 AM)Thomas Radtke Wrote:  Why hasn't it been done for the wp34s?

3D printing technology still has problems with the finish of surfaces. I don't know if there are 3D printers available already which would be able to create a surface as smooth as one would expect it from key caps. It might be possible with some (chemical or temperature) post-processing, though...

I first must admit that I haven't actually seen the results yet; however, micro 3D printing is promising, and should have the expected finish. Post processing | finishing may be required (details) and maybe the first units are vinyl labels, while the process is being refined. The point is that its doable ; just needs the effort.

marcus