Loading YFNX into 41CL

[rprosperi]

(02-26-2015 06:26 AM)Ángel Martin Wrote:  

(02-25-2015 08:00 PM)rprosperi Wrote:  In sequence, I then did

MMUCLR
"YFNX" PLUG1L
MMUEN

to load the CL Extreme Functions.

(the manual says I can now disable the normal CL Extra Functions, but not how to do so?)

If you used the same page# where you had YFNP then that's all done.
Otherwise you'll need to to unplug the YFNP using PLUG, with the "EMPT" switch.

(02-25-2015 08:00 PM)rprosperi Wrote:  Then to load Library-4:
"804040-8120" YPOKE

good, or also with YFNX already plugged you can also do PLUG, "LIB4", 4 - it's easier.

(02-25-2015 08:00 PM)rprosperi Wrote:  Then to load AMC-OSX-Lib4 version into Page-A:

"OSX3 A" PPLUG

Which loads OK, but OSX does not seem to be active.

I reported this issue to Monte a few weeks ago. For the Extended catalogs and the other enhancements to work you need to plug the OS/X module in a lowered number page than the one used by YFNX. The same happens with the original CCD module, it is a conflict in the way YFNX and all CCD-style modules use the polling points - we suspect.

(02-25-2015 08:00 PM)rprosperi Wrote:  Then to load PowerCL-EXT into Page-B:

"PWRX B" PPLUG

CAT2 confirms YFNX 2B, AMC-OSX and PWRCL EXT are present, and the YFNX and PWRCL EXT commands seem to work, but the OSX does not appear to be present.

Did I miss something?

The OSX extensions are not essential for the testing, but I'm used to having this loaded and I'm concerned my setup may not be correct and possibly invalidate any testing.

Suggestions?

To me those extensions are essential, so I hope this helps!

As usual Angel, your answers are most helpful!!

So i can simply install YFNX into Page-9, load LIB#4 and then install OSX3 into Page-8?

Assuming so, can I (with YFNP installed) simply install YFNX into Page-9, then using UPLUG, remove YFNP from Page-8?

Frankly, I consider the OSX extensions essential too! And Rapidly feeling the same about PowerCL.

When I left off using my 41C on a daily basis (early 90's) I had been using a CCD module for some time. In recent years, I traded my CCD module (w/perfect manual, overlay, etc. - sniff) but then upon coming back to the 41, it didn't feel the way I remembered it, and after diging about I realized I had come to think of CCD OS extensions as part of the native system.

These tools Rock Angel, and the beautiful manuals are a joy to read and use!

And soon, on to HEPAX, satisfying a 30-year old itch I could never scratch.