Post Reply 
WP34s flashing procedure
02-27-2015, 10:57 AM (This post was last modified: 02-27-2015 11:51 AM by matthiaspaul.)
Post: #16
RE: WP34s flashing procedure
(02-27-2015 03:49 AM)BarryMead Wrote:  I believe that the "Erase" button shorts the "Erase" pin to "VCC" not "GND". At least that is what the instructions say in the manual.
That's right! Thanks for the correction - this is also what is described in the processor's manual.

Greetings,

Matthias


--
"Programs are poems for computers."
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
WP34s flashing procedure - Dieter - 02-26-2015, 08:10 PM
RE: WP34s flashing procedure - Dieter - 02-26-2015, 10:35 PM
RE: WP34s flashing procedure - Dieter - 02-26-2015, 11:05 PM
RE: WP34s flashing procedure - rprosperi - 02-26-2015, 11:09 PM
RE: WP34s flashing procedure - Dieter - 02-26-2015, 11:17 PM
RE: WP34s flashing procedure - rprosperi - 02-26-2015, 11:21 PM
RE: WP34s flashing procedure - John Galt - 02-27-2015, 02:00 AM
RE: WP34s flashing procedure - Dieter - 02-27-2015, 06:51 AM
RE: WP34s flashing procedure - BarryMead - 02-27-2015, 03:49 AM
RE: WP34s flashing procedure - matthiaspaul - 02-27-2015 10:57 AM
RE: WP34s flashing procedure - walter b - 02-27-2015, 03:25 AM
RE: WP34s flashing procedure - Dieter - 02-27-2015, 07:12 AM
RE: WP34s flashing procedure - walter b - 02-27-2015, 08:22 AM
RE: WP34s flashing procedure - Dieter - 02-27-2015, 07:35 PM
RE: WP34s flashing procedure - John Galt - 02-27-2015, 08:05 PM
RE: WP34s flashing procedure - Dieter - 03-01-2015, 04:26 PM
RE: WP34s flashing procedure - Dieter - 03-01-2015, 09:15 PM
RE: WP34s flashing procedure - Dieter - 03-01-2015, 09:49 PM



User(s) browsing this thread: 1 Guest(s)