Threaded Mode | Linear Mode

isanchez · (This post was last modified: 07-31-2015 08:49 AM by isanchez.)

Hi Bernhard,

maybe we need to launch a crowdfunding initiative! ;-D the thing is to coordinate to all people affected by cathodic failures.

Thanks Katie!, I think you are talking about the card reader board. The display /keyboard circuit board list of components is in table 4.9, where R2* is listed but I can't see in the diagram of page 4.23. I believe in this page it is mentioned as R1*, instead of R2*...but maybe I am wrong.
may I kindly ask you what should I do to reduce the low battery indicator sensitivity (as it is always "on"): to increase or decrease the resistor value?

Kind regards

Ignacio