softkey "KILL"

[Csaba Tizedes]

(08-30-2015 04:35 PM)Brad Barton Wrote:  HALT pauses the program currently being executed. Program execution can be continued after a HALT command. Note the HLT symbol in the upper right of the screen.

KILL stops the program, and exits the program. Program execution cannot be continued after a KILL. Note that HLT is not shown.

This is possible to use on 48 series, as I remember.
Maybe that is possible to HALTing a program after than change to an other program, running that and after that CONTinuing the halted program?
It is possible to running programs parallelly on 48/49/50 series?

Another question: it is possible to running program without LCD / when calc is OFF? Let's say my program running time is very long I throw my 48GX into my bag, I travel to home, during this time my 48 finished his job...?!?

BTW Just for fun: how-long-my-calc-is-OFF:

Code:


TCKSOFF
<< TICKS OFF TICKS SWAP  -  B->R  8192  / >>