AS small alphanumeric signs

[brickviking]

(09-01-2015 09:26 AM)tigger Wrote:  Thank you for your help.
I am in the home Directory. In my home drictory I have many subdirectories. In more than one I used the variables a, b, c (samll letters). These have all different values then the ones which I will get after I put 'a' 'b' 'c' in the stack on the bottom line.

As well I have capital letters in at least one subdirectory. But the HP does not show any numbers after entering those letters in the bottom line. I enter A SPC B SPC C then I hit enter. I get all three [b]capital [/b]letters on the Display.


Why did it work [b]before[/b]? So what did I change?

I have not succed to find a chapter in the Manual:
http://h10032.www1.hp.com/ctg/Manual/c00748644
Could you write a key word under which I can find the chapter I am looking for. There I might find some good examples and explanations.

Variables in subdirectories aren't visible to your session if you're in the Home directory. In that case, you get just the variables in the Home directory. If you hit the VAR key, you can page through all the variables in the Home directory by using NXT key. If you only have six (or less) variables, then NXT won't seem to do anything. Do you see a, b, or c on your softkeys anywhere when you check out all the variables? Also, what's in the top two lines of your calculator? I have this:

Code:


RAD XYZ  DEC C~ 'X'
{HOME}                         09:39  02:SEP

That {HOME} tells me I'm in the Home directory. I have also had {HOME rplprgtut} in that space when I've been in the rplprgtut directory (one I created).

(Post 12)

Regards, BrickViking