Custom FRAM71 Bezels

[rprosperi]

(09-05-2015 02:29 PM)Dave Frederickson Wrote:  24 AWG solid wire was used. Fishing it through the holes was rather tricky, which led me to a modification. I drilled the bottom two holes all the way through to the top of the housing. This allowed me to thread the wire from the top, through the first "contact", loop the wire back through the second contact, and back out the top. I could then pull the wire from the top to "snug it up" rather than trying to push it into the bottom holes from the bottom side of the housing. Then I just clipped the wires off with flush-cutting pliers.

Dave

Very nice solution. By zooming in on the photo, I can now see how the wire penetrates thru to the top (into the page on the photo). Also, this prevents the problem I was asking about; since the there are no loose wire "ends" to catch on, there should be no chance of getting caught on the edge of the board when inserting the OD module into Port-1.