Post Reply 
Key Findings
09-28-2015, 05:40 PM
Post: #3
RE: Key Findings
Another possibility might be to 3D print transparent key caps, with slot in the top. A paper printed key cap can then be slid into the slot to form the top and front side label.

This company does suitably transparent 3D printing but might be a bit expensive!

As always this only addresses the problem of the key cap, not the spring mechanism.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Key Findings - kusmi - 09-28-2015, 10:42 AM
RE: Key Findings - Katie Wasserman - 09-28-2015, 02:36 PM
RE: Key Findings - BruceH - 09-28-2015 05:40 PM
RE: Key Findings - Chris Chung - 09-28-2015, 05:44 PM
RE: Key Findings - mivok - 09-29-2015, 12:38 AM
RE: Key Findings - Chris Chung - 09-29-2015, 01:10 AM
RE: Key Findings - brouhaha - 09-29-2015, 04:46 PM
RE: Key Findings - Dave Frederickson - 09-29-2015, 05:20 PM
RE: Key Findings - brouhaha - 09-29-2015, 11:12 PM
RE: Key Findings - Zweb - 09-29-2015, 04:21 AM



User(s) browsing this thread: 1 Guest(s)