HP-01 Case Opener on TOS
|
10-04-2015, 04:13 PM
(This post was last modified: 10-04-2015 04:19 PM by Geoff Quickfall.)
Post: #9
|
|||
|
|||
RE: HP-01 Case Opener on TOS
Yes, is the short answer, read on.
The HP01 case has a piezo (bender) mounted (epoxied) on the inside back of the case back. The wrench slots for the case wrench are "holes" through to the bender, which is used as the water proof cap on the inside of the case back. The holes (wrench slots) enhance the sound releasing it directly to the air versus muffling in a sealed case. I have the same wrench but the tips project too far into the wrench slots and will bend, deform or puncture the bender. Hence the reduced tips on the HP wrenches. I have 8 of these restored and four needed new benders due to a watch maker using the standard wrench you pictured and destroying the bender through the wrench slots. Probably for a battery change. Of course, if you are very careful and do not run into a 'welded tight' case back, that wrench would work. Cheers, Geoff 35 restored Accutrons and counting! |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP-01 Case Opener on TOS - jjohnson873 - 10-01-2015, 12:39 PM
RE: HP-01 Case Opener on TOS - Massimo Gnerucci - 10-01-2015, 01:36 PM
RE: HP-01 Case Opener on TOS - Geoff Quickfall - 10-01-2015, 04:53 PM
RE: HP-01 Case Opener on TOS - vk6ti - 10-02-2015, 12:04 AM
RE: HP-01 Case Opener on TOS - rprosperi - 10-02-2015, 08:35 PM
RE: HP-01 Case Opener on TOS - striegel - 10-02-2015, 09:16 PM
Adapting a Bulova wrench - striegel - 10-02-2015, 09:37 PM
RE: HP-01 Case Opener on TOS - Accutron - 10-04-2015, 03:11 AM
RE: HP-01 Case Opener on TOS - Geoff Quickfall - 10-04-2015 04:13 PM
RE: HP-01 Case Opener on TOS - Accutron - 10-04-2015, 06:35 PM
RE: HP-01 Case Opener on TOS - Geoff Quickfall - 10-04-2015, 09:39 PM
RE: HP-01 Case Opener on TOS - BobVA - 10-05-2015, 11:26 PM
|
User(s) browsing this thread: 2 Guest(s)