Plastic (or Aluminum as you want) case for NP-25

[Waon Shinyoe]

(12-16-2015 04:33 PM)walter b Wrote:  Quite nice! But were will we put the overlays?

d:-?

The original overlay was printed on the NP-25's PCB. The space is quite limited while NP-25 can emulate multiple models. (HP 21, HP 25C and HP 33C) Even though, Chris managed to squeezed into quite a lot nomenclatures.

If we want a customized overlay for each ROM, then the overlay should be switchable, which may require the HP-41 series design. I can make the front edge taller to hold a new overlay. Thanks Walter, I will consider the design. Maybe the new design will be adopted after I customize the overlays.