HP Forums / Not HP Calculators / Not quite HP Calculators - but related v / [SUCCESS] 34s project closed

Post Reply 
[SUCCESS] 34s project closed
02-14-2014, 11:31 PM
Post: #10
Tugdual Offline
Senior Member
 		Posts: 764
Joined: Dec 2013
RE: 34s project initiated
Okay, received the second hand 30b. Quite a good one finally, better quality than what I expected initially. I also found a USB to RS232 cable so I just did a quick and dirty adapter. Erased the 30b successfully but MySamba doesn't connect.
I wired the 9 pins RS232 as follow
Pin 2 (RXD) <-> J35 RX0
Pin 3 (TXD) <-> J33 TX0
Pin 5 (GND) <-> J34 GND
I also tried to cross J33 & J35 but MySamba doesn't connect.

Checked Windows Settings and the COM is parametered 9600 8N1.
Does any body know if I'm doing something wrong?

Right now the 30b is bricked, should I do something special to reactivate the programming mode after a failure?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[SUCCESS] 34s project closed - Tugdual - 02-06-2014, 09:44 PM
RE: 34s project initiated - Tugdual - 02-08-2014, 03:22 PM
RE: 34s project initiated - walter b - 02-08-2014, 05:42 PM
RE: 34s project initiated - Tugdual - 02-11-2014, 12:16 PM
RE: 34s project initiated - Bit - 02-11-2014, 03:43 PM
RE: 34s project initiated - Tugdual - 02-11-2014, 04:41 PM
RE: 34s project initiated - Tugdual - 02-14-2014 11:31 PM
RE: 34s project initiated - walter b - 02-15-2014, 07:59 AM
RE: 34s project initiated - Tugdual - 02-15-2014, 08:42 AM
RE: [SUCCESS] 34s project closed - Tugdual - 03-08-2014, 01:20 PM



User(s) browsing this thread: 3 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication