HP Forums / Not HP Calculators / Not quite HP Calculators - but related v / [SUCCESS] 34s project closed

Post Reply 
[SUCCESS] 34s project closed
02-15-2014, 08:42 AM (This post was last modified: 02-15-2014 09:07 AM by Tugdual.)
Post: #12
Tugdual Offline
Senior Member
 		Posts: 764
Joined: Dec 2013
RE: 34s project initiated
Thanks Walter, I have checked the Troubleshooting guide and didn't find any clue there so far. Hope the RS232 on the calculator is still operating...

Do I have to wire RTS, CTS and other "non used" pins on the PC DB9 (as mentioned below)?
[Image: 9f9f3a.gif]

Edit: Just in case, I also wired the additional pins as mentioned above. Not any better.

I guess this is the end of this project.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[SUCCESS] 34s project closed - Tugdual - 02-06-2014, 09:44 PM
RE: 34s project initiated - Tugdual - 02-08-2014, 03:22 PM
RE: 34s project initiated - walter b - 02-08-2014, 05:42 PM
RE: 34s project initiated - Tugdual - 02-11-2014, 12:16 PM
RE: 34s project initiated - Bit - 02-11-2014, 03:43 PM
RE: 34s project initiated - Tugdual - 02-11-2014, 04:41 PM
RE: 34s project initiated - Tugdual - 02-14-2014, 11:31 PM
RE: 34s project initiated - walter b - 02-15-2014, 07:59 AM
RE: 34s project initiated - Tugdual - 02-15-2014 08:42 AM
RE: [SUCCESS] 34s project closed - Tugdual - 03-08-2014, 01:20 PM



User(s) browsing this thread: 2 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication