HP Forums / Not HP Calculators / Not quite HP Calculators - but related v / [SUCCESS] 34s project closed

Post Reply 
[SUCCESS] 34s project closed
02-15-2014, 04:26 PM
Post: #14
Tugdual Offline
Senior Member
 		Posts: 764
Joined: Dec 2013
RE: [CLOSED/FAILED] 34s project initiated
(02-15-2014 04:11 PM)Paul Berger (Canada) Wrote:  You do know that for connecting the calculator to a RS-232 port you need a level translator in between them? The serial port on the calculator is not RS-232, it is an asynchronous serial port but the signal levels switches between 0V and 3V.
Hi Paul, no I didn't know. So I connected the outpout of the RS232 straight on the internal port. Do you think I have damaged the calculator?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[SUCCESS] 34s project closed - Tugdual - 02-06-2014, 09:44 PM
RE: 34s project initiated - Tugdual - 02-08-2014, 03:22 PM
RE: 34s project initiated - walter b - 02-08-2014, 05:42 PM
RE: 34s project initiated - Tugdual - 02-11-2014, 12:16 PM
RE: 34s project initiated - Bit - 02-11-2014, 03:43 PM
RE: 34s project initiated - Tugdual - 02-11-2014, 04:41 PM
RE: 34s project initiated - Tugdual - 02-14-2014, 11:31 PM
RE: 34s project initiated - walter b - 02-15-2014, 07:59 AM
RE: 34s project initiated - Tugdual - 02-15-2014, 08:42 AM
RE: [CLOSED/FAILED] 34s project initiated - Tugdual - 02-15-2014 04:26 PM
RE: [SUCCESS] 34s project closed - Tugdual - 03-08-2014, 01:20 PM



User(s) browsing this thread: 2 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication