Resetting default libraries on 50G

[rprosperi]

(02-08-2016 08:59 PM)BuckeyeEngineer Wrote:  

(02-08-2016 03:15 PM)rprosperi Wrote:  Download the font to somewhere "safe" such as Port-2 (or even in the SD card (Port-3) if you have an SD card installed), then just recall it to the stack and use the command ->FONT, so it looks like:

"2:TI89.FON RCL ->FONT"

The above is best for a program to save (e.g. along with other default settings in your STARTUP program). You can also load it interactively using MODE, DISP, then browse to where you saved it.

You can restore any missing original default libraries by downloading them from hpcalc.org, then just installing them like any other library.

HTH

I can't seem to find any of the default libraries on hpcalc.org. Can you point me towards what I need? Thanks again.

Truly sorry, I was thinking of the 48GX libraries when I posted this. Which libraries are you thinking of, that seem to be missing? As I think about it, I don't recall the 50g coming with libraries installed, and I can't check as all mine are set up the same way with my own config/libraries, etc.