(50g) Mirror the stack
|
03-19-2016, 06:13 PM
Post: #9
|
|||
|
|||
RE: (50g) Mirror the stack
(03-19-2016 04:54 PM)Vtile Wrote:On your free time you might check this page: http://www.hpcalc.org/details.php?id=5142(03-19-2016 04:38 PM)Tugdual Wrote: The Hp 50g supports two command sets: user RPL and system RPL.That what I was suspecting, but I were on the (wrong) impression that AUR constains also SysRPL commands. I think I stay away from it. UserRPL mirror does mirror 1000 stack entries in about 6½ seconds and 2000 entries before I can get new cup of coffee, so there is no need for me for more speed. Edit.. It seems calculator starts to "fail" above 1k high stack, not bad. This is a pretty good introduction to sysRPL. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
(50g) Mirror the stack - Vtile - 03-19-2016, 02:23 PM
RE: (50g) Mirror the stack - Gerald H - 03-19-2016, 02:50 PM
RE: (50g) Mirror the stack - rprosperi - 03-19-2016, 05:23 PM
RE: (50g) Mirror the stack - Vtile - 03-19-2016, 03:01 PM
RE: (50g) Mirror the stack - Tugdual - 03-19-2016, 04:38 PM
RE: (50g) Mirror the stack - Vtile - 03-19-2016, 04:54 PM
RE: (50g) Mirror the stack - Tugdual - 03-19-2016 06:13 PM
RE: (50g) Mirror the stack - Tugdual - 03-19-2016, 05:08 PM
RE: (50g) Mirror the stack - Vtile - 03-19-2016, 05:53 PM
RE: (50g) Mirror the stack - Claudio L. - 03-19-2016, 06:32 PM
RE: (50g) Mirror the stack - Vtile - 03-19-2016, 06:38 PM
|
User(s) browsing this thread: 2 Guest(s)