Converting from one base to another?

[smp]

(04-12-2016 04:44 AM)cyrille de brébisson Wrote:  Hello,

The base editor is actually a quite OK convertor by itself...

Hi Cyrille,

Thanks very much for your attention and advice.

I have about 1000 8080 instructions in hexadecimal that I want to load into M1 for my 8080 emulator. That is why I was trying to create a program. I simply want to enter a starting address location for M1, and then enter hex byte after hex byte, with the program converting the hex bytes into decimal numbers and storing them sequentially into M1. I don't think the Prime capability for doing the base conversion would be good for this. If I'm missing something, please let me know.

Thanks,
smp