pyILPER Version 1.3.3 released

[Howard Owen]

I just flashed my PIL-Box to version 1.6. (Thanks JF!) I installed the latest pyILPER on my Mac using anaconda and fired it up. After selecting the right serial port and baud rate my HP-71 is talking to pyILPER just fine.

However the terminal is acting as it did before the upgrade. After an INIT(3) and after loading the contents of the PILIMAGE.dat LIF, My VER$ is "HP71:2CDCC KBD:C RCPY:E HPIL:1B" After running PILTERM I type on my mac's keyboard and the characters don't show up on the terminal until I press attn on the 71. At that point they show up and are processed by the 71. My pyILPER version is 1.3.3.

Thanks for any help you can offer.