HP Forums / HP Calculators (and very old HP Computers) / General Forum v / HP41C - workaround for the SIZE? missing

Post Reply 
HP41C - workaround for the SIZE? missing
04-19-2016, 03:42 PM
Post: #3
RMollov Offline
Member
 		Posts: 264
Joined: Dec 2013
RE: HP41C - workaround for the SIZE? missing
(04-19-2016 02:49 PM)wojtek Wrote:  How would you determine the number of data registers set in the past (and forgotten) in the HP41C?
There is no SIZE? command in this calculator.
Very simple. Start RCL-ing from maximum possible register number down. Depending on how much memory is available will take you less than a minute to figure it out. Wink
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: HP41C - workaround for the SIZE? missing - RMollov - 04-19-2016 03:42 PM



User(s) browsing this thread: 4 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication