Prime number finder HP11C?
|
06-20-2016, 12:20 AM
Post: #26
|
|||
|
|||
RE: Prime number finder HP11C?
(06-19-2016 09:28 PM)jbhp55 Wrote: There is another ":0" after the "<>". So : "FP(P)<>0:0:1+" etc. Thanks Japp, this works, though when entering the equation, you must use FP(P÷D)<> rather than FP(P/D)<> as shown, else the solver treats "P/D" as a variable. Initially I understood the directions to mean that subsequent presses of [PRIM] would seek the next Prime number, however a little trial and error shows the program increments by 2 then tests for Prime and reports, and one just repeats hitting [PRIM] until the next is found. Thanks again for sharing this! --Bob Prosperi |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)