Threaded Mode | Linear Mode

Ángel Martin · (This post was last modified: 08-17-2016 07:45 PM by Ángel Martin.)

(08-17-2016 03:00 PM)mfleming Wrote:
Quote:Were you able to edit the XROM id#'s to eliminate the conflicts?
If my understanding of HEPAX RAM is correct, the RAM page has the same XROM id# as the physical page in which it is installed. So my conflicts were the result of putting HEPAX RAM in ports 3 & 4. Now that RAM is in port 1 (with future expansion to port 2) there is no conflict (yet!).

Such setup is just a convention, but doesn't need to be like that. You can always edit the XROM id# manually to remove conflicts, even *after* it's been assigned by the automated sequence (or by the HEPX4/8/16 functions). All it takes is modification of the first byte at address p000 (p being the page). Doing so won;t mess with the hepax chain, so it's totally safe from that side.