pyILPER Version 1.3.4 released

[dayd]

Thank you Joachim,

The printer was of course enabled and I’ve got ‘only’ a HP-41CX as controller but your hint was good as I pursued it with the following commands: MANIO, 3 SELECT (the third device in the loop being the printer), PRA and voilà, it worked. Back to AUTOIO mode it still works.
I was assuming that each time I unplug/plug the 82160A HP-IL Module, the system was back to his default state (?). I don’t have other HP-IL special module, like Extended IO to investigate further what’s really going on.
A bit off topic, I’m still looking for the other way around, meaning, how to make, on my computer, text files that I can open with ED on the 41CX (I open a thread http://www.hpmuseum.org/forum/thread-6552.html but got no answers).

Thanks’ again for the great work with pyILPER,
Best regards,
André